HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
330
:HELLO MANAGER.SYS,INSTALL;HIPRI
• Take appropriate corrective measures, and run the installer again.
• Contact the Response Center if further assistance is required.
30 Message The installer failed to create the AUTOPSTR process (INSTERR
#30)
Cause Occurs in AUTOINST only: The CREATEPROCESS intrinsic returned an
error status when attempting to execute AUTOPSTR.INSTALL.SYS.
Either the program file is missing or the indirect store file,
TMPSTR02.INSTALL.SYS, is missing or is empty.
Action • Type LISTF TMPSTR02.INSTALL.SYS,2 to verify it exists and is not
empty.
• Type LISTF AUTOPSTR.INSTALL.SYS to verify it exists. If not,
restore AUTOPSTR from the SUBSYS tape.
• Contact the Response Center if further assistance is required.
31 Message Installation can only be performed from the CONSOLE. (INSTERR
#31)
Cause For AUTOINST: The installer has determined the user's current logon
LDEV is not the system console and the usage type is not PowerPatch.
For HPINSTAL: HPINSTAL determined that your current logon LDEV is
not the system console, which is required for Phase II.
Action • For AUTOINST: The installer must be executed from the system
console only for all options except PowerPatch. Log onto the
CONSOLE and run the installer again.
• For HPINSTAL: You must perform Phase II from the system console.
Log on to the console and run HPINSTAL again.
32 Message Failed to obtain passwords for the IFILE: ifilename (INSTERR
#32)
Cause The call to the AIFACCTGET intrinsic returned a nonzero status.
• If the USL, UXL, UNL groups were not purged prior to starting the
installation, purge them and restart the installation procedures. Type:
:LISTF I???????.USL.SYS.
• If the file INDIRECT.USL.SYS exists, purge it, and run the installer
again.
• Take appropriate corrective measures, and run the installer again.
• Contact the Response Center if further assistance is required.
33 Message CHKLSTSL.INSTALL.SYS does not exist. (INSTERR #33).
Cause The file CHKLSTSL is created during patch selection, and is accessed
immediately. This error can occur if the file is purged, or its name is
somehow corrupted.
Action • Run the installer again to re-create the file.
• Contact the Response Center if further assistance is required.