HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
329
:FILE T;DEV=TAPE
:RUN STORE.PUB.SYS;INFO=
RESTORE &
T;I???????.USL.SYS;SHOW
• Be sure to use the appropriate SUBSYS tape. Run the installer again
after the installation files have been restored. Contact the Response
Center if further assistance is required.
27 Message The installer does not support streaming external jobs from
within installation files. Job processing: ifilename (INSTERR
#27)
Cause A JOB (SUPACCT or IFILE) includes a STREAM filename command
which is not allowed by the installer.
Action • If the USL, UXL, UNL groups were not purged prior to starting the
installation, purge them and restart the installation procedures. Type:
:LISTF I???????.USL.SYS.
• If the file INDIRECT.USL.SYS exists, purge it.
• Take appropriate corrective measures, and run the installer again.
• Contact the Response Center if further assistance is required.
28 Message Internal error encountered at: location (INSTERR #28)
Cause The installer was unable to find information on a streamed job. Either
SUPACCT or one of the installation jobs failed to produce a spool file for
the installer to find or the installer lost track of the JOB number. The
location number specified in the error message is a location number
within the installer code and should be included with all communications
with the Response Center.
Action • Ensure the spooler has been started on the LP device. Start the
spooler by entering:
:SPOOLER LP;START
:LISTF I???????.USL.SYS.
• If the file INDIRECT.USL.SYS exists, purge it.
• Determine the current job from the HPINSTFL file and check the job's
existence and/or termination. Use SHOWJOB to find if the job is still
running and LISTSPF to find if there is a spoolfile.
• Take appropriate corrective measures, and run the installer again.
• Contact the Response Center if further assistance is required.
29 Message Unable to obtain CONSOLE LDEV#. (INSTERR #29)
Cause The installer assigns the value of the CI variable HPCONSOLE to the
JCW TMPJCW1 and then gets the value of the JCW through the intrinsic
FINDJCW. This error results when FINDJCW returns an error status.
Action • Type SHOWJCW to determine whether the SETJCW command
succeeded.
• If TMPJCW1 does not display, attempt to set it manually.
• If TMPJCW1 cannot be set manually, log on again: