HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
328
Action If the USL, UXL, UNL groups were not purged prior to starting the
installation, purge them and restart the installation procedures. Type:
:LISTF I???????.USL.SYS.
• If the file INDIRECT exists, purge it.
• Take appropriate corrective measures, and run the installer again.
• Contact the Response Center if further assistance is required.
23 Message An installation job stream has failed. Job streaming:
ifilename (INSTERR #23)
Cause An installation job aborted abnormally or the installer could not find the
job's spoolfile.
Action • Ensure the spooler has been started on the LP device. Start the
spooler by entering:
:SPOOLER LP;START
• Use an appropriate text editor and view the job's spoolfile to
determine why the job failed (the PRINT command may also be used).
If you need the job number, use an editor to view HPINSTFL. The job
numbers are listed at the end of HPINSTFL. Any command which
leaves the JCW JCW set to FATAL will cause the installer to
determine the job failed.
• Take appropriate corrective measures, and run the installer again.
• Contact the Response Center if further assistance is required.
24 Message 24 Not used
25 Message Unable to build a temporary file. (INSTERR #25)
Cause The installer failed to build a temporary file using the BUILD command.
Action • Check for free temporary disk space to build file. There are two
methods for obtaining additional disk space:
— Use the ALTERVOL command in VOLUTIL to set the permanent
and transient space allocation assignments to 100% on all system
volumes except LDEV 1.
— Store user files to tape and them purge them. Restore the files
from tape at the end of the installation.
• Take appropriate corrective measures, and run the installer again.
• Contact the Response Center if further assistance is required.
26 Message Unable to recover installation file processing. (INSTERR #26)
Cause The installer was stopped and restarted during IFILE processing but
could not find the last IFILE it was working when stopped.
Action • A required installation file has been purged from the system. Restore
I???????.USL.SYS from the SUBSYS tape: