HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
SETUP Error Messages (SETERR)
319
• Contact the Response Center if further assistance is required.
34 Message Failed to copy initialization file SETINIT. SETUP will
terminate.
Follow the instructions in your installation manual to
continue. (SETERR #34)
Cause SETUP.INSTUTIL failed when attempting to copy SETINIT.INSTUTIL to
SETUPYES.INSTALL.
Action • Ensure that the file SETINIT.INSTUTIL exists.
• Ensure that no file equation exists for SETUPYES.INSTALL.
• Purge SETINIT.INSTALL in both the permanent and temporary
domains.
• Execute SETUP.INSTUTIL.
• Contact the Response Center if further assistance is required.
35 Message 35 Not used
36 Message Unable to purge the account mpe_hpslt. (SETERR #36)
Cause SETINIT failed when attempting to purge the account mpe_hpslt.
Action • Ensure that no files are open in the account.
• Purge the account from your terminal.
• Execute SETINIT.INSTALL.
• Contact the Response Center if further assistance is required.
37 Message Unable to purge the account mpe_hpupdate. (SETERR #37)
Cause SETINIT failed when attempting to purge the account mpe_hpupdate.
Action • Ensure that no files are open in the account.
• Purge the account from your terminal.
• Execute SETINIT.INSTALL.
• Contact the Response Center if further assistance is required.
38 Message Unable to purge the group mpe_cdgroup. (SETERR #38)
Cause SETINIT failed when attempting to purge the group mpe_cdgroup .SYS.
Action • Ensure that no files are open in the group.
• Purge the group from your terminal.
• Execute SETINIT.INSTALL.
• Contact the Response Center if further assistance is required.
39 Message MPE release-dependent CI variables could not be created.
SETINIT
will terminate. (SETERR #39)