HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
SETUP Error Messages (SETERR)
315
Action • Manually VSCLOSE/VSOPEN the volume set from the system
console.
• Contact the Response Center if further assistance is required.
19 Message SETINIT will terminate. To continue, you must go to
the system console and VSOPEN mpe_volsetname. If necessary,
run AVRSCSI.INSTALL
to put the volume set containing SETUP.INSTUTIL online.
(SETERR #19)
Cause SETINIT is attempting to VSOPEN a volume set that is in the “LONER”
state, but is unsuccessful.
Action • Go to the system console and VSOPEN the volume set name.
• Execute SETUP.INSTUTIL.
• Contact the Response Center if further assistance is required.
20 Message CD v.uu.ff.SYS has garbage in its last record. SETUP
will terminate. Follow the instructions in your installation
manual
to continue. (SETERR #20)
Cause The GRPNAMES data file is corrupted.
Action • Ensure the no file equation exists for GRPNAMES.
• Execute SETINIT.INSTALL.
• Contact the Response Center if further assistance is required.
21 Message You must execute SETUP.INSTUTIL prior to executing SETINIT.
(SETERR #21)
Cause SETINIT uses a secondary CI script called OLDACCTS to establish MPE
release-dependent variables. This script is built by SETUP.INSTUTIL,
and is deleted by SETUP.INSTUTIL upon normal termination. Therefore,
SETUP.INSTUTIL must be executed first, and it must fail prior to
SETINIT.
Action • Ensure that the CD containing the INSTUTIL.SYS group is online.
• From MANAGER.SYS,INSTALL, execute SETUP.INSTUTIL.
• If SETUP.INSTUTIL fails, execute SETINIT.INSTALL.
• Contact the Response Center if further assistance is required.
22 Message Unable to set file equation for the file HPINSTAL.INSTALL.
SETUP
will terminate. Follow the instructions in your installation
manual
to continue. (SETERR #22)
Cause SETUP.INSTUTIL forces the file HPINSTAL.INSTALL onto LDEV 1 by
setting a file equation prior to copying the file from compact disk.
However, SETUP.INSTUTIL failed when attempting to set the file
equation.
Action • Do a LISTEQ to determine the file equations that have been set.