HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
SETUP Error Messages (SETERR)
312
• If GRPNAMES still an invalid format, contact the Response Center.
9 Message A specified account was not successfully created. SETUP
will terminate. Follow the instructions in your installation
manual
to continue. (SETERR #9)
Cause One of the accounts in the GRPNAMES data file could not be successfully
created.
Action • Ensure that your log on, MANAGER.SYS,INSTALL has all MPE
capabilities.
• Ensure that no other process has accessed the account.
• If so, instruct the user to log off.
• Execute SETINIT.INSTALL.
• Contact the Response Center if further assistance is required.
10 Message Unable to successfully bind to the group group.account
. SETUP will terminate. Follow the instructions in your
installation
manual to continue. (SETERR #10)
Cause SETUP was unable to create a group that was listed in the GRPNAMES
data file.
Action • Type the following command to ensure that the group does not exist.
:LISTGROUP GROUP.ACCOUNT
• Execute the SETINIT script to continue the SETUP.INSTUTIL. If the
group.account does not exist and you are unable to create it, ensure
that your MANAGER.SYS,INSTALL (user.account,group) has full
MPE capabilities.
• Contact the Response Center if further assistance is required.
11 Message The file filename could not be successfully copied
to INSTALL.SYS. SETUP will terminate. Follow the instructions
in
your installation manual to continue. (SETERR #11)
Cause SETUP copies all files from the CD vuuff .SYS group on the compact disk
to INSTALL.SYS group for use by HPINSTAL. The file set consists of
HPINSTAL and all of its data files. This error is a result of the inability to
copy one of the HPINSTAL files from the CD vuuff .SYS group into the
INSTALL.SYS group.
Action • Perform the following command to determine if the file exists and
contains records.
:LISTF FILENAME. CD VUUFF .SYS,2
• Perform the following command to determine if the file exists in
INSTALL.SYS:
:LISTF FILENAME .INSTALL.SYS,2
• Ensure that the file is not busy.
• Then execute SETINIT.INSTALL.