HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Common Modification Process Errors
305
WARNING: UPDATE tried to find 60,000 sectors of contiguous disk
space on LDEV1 for its work, but it could only find nnnnnnn
sectors. Before continuing, refer to the Installation Manual for
instructions on collecting enough contiguous space on LDEV1 for
the update. If you still have questions after attempting the
procedures outlined in the manual, call your HP support
representative for help.
You may override this warning and continue with the update, but
HEWLETT-PACKARD STRONGLY DISCOURAGES THIS COURSE OF ACTION.
DO NOT override this warning unless you have a full backup
available and the time to REINSTALL your system. If UPDATE runs
out of space on LDEV1, you risk having to REINSTALL.
Override this warning message [OVERRIDE/NO; default=NO]?
At the end of UPDATE, where the system normally boots, the system will stop. The operator must boot the
machine manually. Messages will stay on the console. The console will have the following message on it.
ERROR.
This UPDATE did not restore all files from the tape.(UPDERR 1001)
There were # files not restored because of out of disk space. (1)
There were # files not restored for other than disk space
reasons. (2)
There is more information about the error conditions in previous
messages.
START the system, create more free disk space and run this UPDATE
again. (1)
Correct the problems and run this UPDATE again. (2)
Correct the problems, START the system, create more free disk
space and run this UPDATE again. (3)
END of LOAD (update).
INSTALL Group Capabilities
The INSTALL group is created with certain capabilities which AUTOINST needs to run. If these capabilities are
not present, the following message is displayed:
Program requires more capabilities than group is allowed.
(LDRERR505)
Native mode loader message 505 UNABLE TO LOAD PROGRAM TO BE RUN.
(CIERR 625)
If this message appears on the console where AUTOINST is invoked, use CHGROUP to change to the PUB.SYS
group, use ALTGROUP to add the BA, IA, PM, MR, DS, and PH capabilities to the INSTALL group. Use
CHGGROUP to return to your original group.
Zero Installation Files
When installation files are streamed, progress messages display. The message may indicate zero installation
files. This only means that the products you are installing do not require an installation file. AUTOINST
continues with the product installation.