HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix E
CD-ROM Resources
Adding a CD-ROM Drive
250
• If you are on a 5.0 or greater system:
ISL>ODE
ODE>RUN MAPPER
Refer to “5.3 Listing the System Configuration” in Chapter 5, “Modifying Your System,” for procedural
information. Also refer to the Offline Diagnostics Environment (ODE) User’s
Manual.
The system displays the I/O configuration for the system. You need to check whether the CD-ROM
drives have been configured correctly by seeing whether MPE/iX recognizes them. Example hardware
configuration paths for HP-IB CD-ROM drives are shown below. Note the paths for your drives are
likely to have different values, but the paths listed in your MAPPER output need to match the paths you
entered with the AD command in the SYSGEN IO configurator.
Type
Path Component Name ID
----------------------------- ------
52.3.0 CD-ROM Drive HPA1999A
52.4.0 CD-ROM Drive HPA1999A
ODE>EXIT
• If you are on a 4.0 or 4.5 system:
— Please ensure that all peripherals are powered on before you run IOMAP. If a peripheral is not
powered on, it will not appear on IOMAP as an I/O component.
— If you need information about hardware device IDs, print the file IODFAULT.PUB.SYS to your
screen. This file contains ID numbers and associated parameters for hardware devices. You can
display this file when the system is up and you have the system prompt.
ISL>IOMAP
The system a screen similar to:
IOMAP Revision 2817 April 26, 1988
IOMAP Running: ce81
This program has the capability to identify the configuration of
the system and its I/O paths and devices. Many of the components
of the I/O system can be tested with selftest and loopback
diagnostics.
.
.
.
Do you wish to modify any program parameters? N
Record or print the I/O configuration table displayed on the screen.
This display shows all path names of the I/O components. These pathnames will be needed later to
add to the SYSGEN I/O configuration. This screen is a sample of an IOMAP from an HP 3000 Series
950 system. The IOMAP display on your screen may differ significantly from the one below.
Identify: Loop 1: All I/O components are being....
Processor Identification:
.
.
.
Type SW Rev Tests
Path Component Name ID Mod Hdwr Firm Avail
______ ___________________________ ___ ___ ___ ___ ___
8 A1700-50005 Channel Adapter 8H 5H 10H 0 0 ST LB
12 28640-60001-802.3-LAN 2H 4H 52H 0 0 ST LB