HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix D
Backdating Your System
Finishing Up
221
5. Exit NMMGR.
6. Stream JCONFJOB.
:STREAM JCONFJOB.NET.SYS
The JCONFJOB.NET.SYS stream is required for all systems. It includes information files that describe the
supported set of servers and services. These information files are used to build a configuration file called
DADCONF.NET.SYS. Wait until the above jobstream is complete before continuing with the next step.
Set Passwords and Lockwords
For additional information about these steps, refer to “Setting Passwords and Lockwords” in Chapter 6,
“Finishing the Process.”
1. Set passwords for HP recommended accounts.
:ALTACCT acctname;PASS=password
AUTOINST does not require the removal of passwords. However, if these accounts and users do not have
passwords, Hewlett-Packard recommends that you set them now.
2. Set passwords for HP recommended users.
:ALTUSER username;PASS=password
These users were created or modified to have OP (System Supervisor) and/or PM (Privilege Mode)
capabilities. Hewlett-Packard recommends that you set passwords for these users.
3. Set passwords for MANAGER.SYS
:ALTACCT SYS;PASS=password
:ALTUSER MANAGER;PASS=password
4. Identify system files as these should never have lockwords.
:SYSGEN
sysgen>SYSFILE
sysfile>SHOW
Record the list of files
sysfile>EXIT
sysgen>EXIT
5. Reapply or add lockwords to the system, as required.
If you removed any lockwords from the system earlier, reapply them now. Do not apply lockwords to
system files.
BIND HPOFFICE HPSKTS JAVA SYS HPX11
CLL HPOPTMGT HPSPOOL RJE SYSLOG NETWARE
CONV HPPL85 INDHPE SAMBA SYSMGR SOFTREP
HPLANMGR HPPL87 INTSETUP SNADS TELESUP
HPNCS HPPL89 ITF3000 SUPPORT WWW
MANAGER.SYS FIELD. HPPL85 MGR.SNADS MGR.JAVA
MGR.HPOFFICE MGR.TELESUP MGR.SYSMGR