HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Chapter 6
Finishing the Process
6.4 Setting Passwords, Lockwords, and UDCs
148
6.4 Setting Passwords, Lockwords, and UDCs
To set passwords, lockwords, and UDCs:
1. Review account security.
Refer to Manager’s Guide to MPE/iX Security and the HP Security Monitor/iX Managers Guide.
2. Set passwords for HP recommended accounts, if these accounts do not have passwords, see Table 6-1.
:ALTACCT acctname;PASS=password
Password recommended accounts.
3. Set passwords for users that were created or modified to have OP (System Supervisor) and/or PM
(Privilege Mode) capabilities, see Table 6-1 on page 148.
:ALTUSER username;PASS=password
Password Recommended Users
4. Confirm that passwords are set for SYS account and user MANAGER.SYS.
5. Identify system files.
:SYSGEN
sysgen>SYSFILE
sysfile>SHOW
Record the list of files.
sysfile>EXIT
sysgen>EXIT
6. Reapply or add lockwords to the system, as required. Refer to your list for the previously lockworded files.
:RENAME filename,filename/lockword
7. Enable UDCs. Purge the COMMAND file created during the process and rename your temporary COMMAND
file.
:PURGE COMMAND.PUB.SYS
:RENAME command_name,COMMAND.PUB.SYS
8. If your users plan to use POSIX features on MPE/iX, and if it is not already set, set a special UDC.
:SETCATALOG HPPXUDC.PUB.SYS;SYSTEM;APPEND
Table 6-1 Recommended accounts for passwords
BIND HPOFFICE HPSKTS JAVA SYS
CLL HPOPTMGT HPSPOOL RJE SYSLOG
CONV HPPL85 INDHPE SAMBA SYSMGR
HPLANMGR HPPL87 INTSEUP SNADS TELESUP
HPNCS HPPL89 ITF3000 SUPPORT WWW
MANAGER.SYS FIELD. HPPL85 MGR.SNADS MGR.JAVA
MGR.HPOFFICE MGR.TELESUP MGR.SYSMGR