HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Chapter 6
Finishing the Process
6.3 Recovering Staging Areas
147
6.3 Recovering Staging Areas
Recover staging areas, if they existed and if you need the previously existing staging areas.
To recover your staging areas:
1. Check that HP Stage/iX is not already initialized.
:STAGEMAN STATUS
The following message displays if HP Stage/iX is not initialized:
STAGEMAN A.00.00, (C) Hewlett-Packard Co., 1995. All Rights
Reserved.
*Warning: HP Stage/iX is not initialized (STAGEMAN 1090)
STAGEMAN> status
The HP Stage/iX environment is not initialized.
2. Type at the MPE/iX colon prompt:
:STAGEMAN INITIALIZE
The following message displays when HP Stage/iX initializes:
STAGEMAN A.00.00, (C) Hewlett-Packard Co., 1995. All Rights
Reserved.
STAGEMAN> initialize
Successfully initialized the HP Stage/iX environment.
3. Start HP Stage/iX.
:STAGEMAN
STAGEMAN>
4. For each staging area that existed:
STAGEMAN>RECOVER sa_name
where sa_name is the name of each staging area.
5. Validate each staging area.
STAGEMAN>VALIDATE sa_name
• Recovering Staging Areas completed. Go to the next section on your checklist.