HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Chapter 5
Modifying Your System
5.13 Applying the CSLT Modification
131
Reinstall Tasks
10. Proceed with the re-installation.
CAUTION DO NOT DO THIS UNLESS YOU ARE PERFORMING A REINSTALL. IT DESTROYS
ALL THE EXISTING SYSTEM AND USER FILES IN THE
MPEXL_SYSTEM_VOLUME_SET!
a. Type at the ISL prompt:
ISL>install
The system displays initialization and restore messages.
b. Go to Step 11.
11. Confirm the date and time.
If the date and time displayed are not correct, enter N, and enter the correct date and time. If you do not
respond within 15 seconds, the system continues.
The system displays an initialization message.
The system continues to restore the files from the CSLT. This process can take 10–25 minutes. During
this process, the system displays initialization and restore messages.
If AUTOBOOT is ON, the system will boot from the AUTOBOOT file unless interrupted by you within ten
seconds. If AUTOBOOT is OFF
(as recommended), you do not have to watch for the reset prompt.
The system displays the following message regardless of whether or not AUTOBOOT is enabled.
Restoring system file "C0040000.DIAG.SYS"
END of LOAD (update).
Auto boot in progress.
When the Update or Install process completes, the SPU resets.
12. Remove the CSLT tape.
• Applying the CSLT Modification completed. Go to the next section on your checklist.