HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Chapter 5
Modifying Your System
5.11 Securing the System
124
a. Issue the HP Predictive Support command:
:RUN PSCONFIG.PRED.SYS
This run of HP Predictive Support may include a transfer of files to the Hewlett-Packard Response
Center. If a transfer is needed, be sure it completes because the system update overwrites the
information in the file PSDCFILE.PRED.SYS.
b. Select item 4, Configuration, from the Main menu.
c. Select item 5, Schedule, from the Configuration Options menu.
d. Select item 1, Schedule (on/off), from the Schedule menu.
e. Set the preference, at the prompt, type OFF:
Type schedule preference (on/off) or // to cancel: __
f. Exit the program, at the prompt, type EXIT:
Type an item number, an item key, or a command: __
g. Save the values, at the prompt, type YES:
Do you wish to save these values (Y/N)? __
h. Go to Step 6.
6. Lower session and job limits.
:LIMIT 0,0
7. Warn, then log users off.
:WARN@ PLEASE LOG OFF! SYSTEM UPDATE ABOUT TO BEGIN
Wait approximately five minutes, make sure users have saved their work and logged off, then abort job or
sessions still executing. Use the SHOWJOB command to determine session and job numbers. Then, for each
job and session still executing (except yours), type:
:ABORTJOB #Jnn
:ABORTJOB #Snnn
where:
Jnn the ID number for each job to be aborted.
Snnn the ID number for each session to be aborted.
8. Deactivate NS 3000/iX, if applicable.
:NSCONTROL STOP
:NSCONTROL ABORT
:NETCONTROL STOP
9. Terminate logging processes.
a. Enter the following command to determine if user logging processes are running:
:SHOWLOGSTATUS
b. If logging processes are running on your system, a message similar to the following will be displayed:
LOGID CHANGE AUTO USERS STATE CUR REC MAX REC % USED CUR FSET
SHPLOGID YES YES 1 ACTIVE 120 10016 1% 1
ORBLOGID YES YES 9 ACTIVE 3812 10016 38% 1
If no logging processes are running, go to Step 10.
c. Terminate logging processes as shown below.