HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Chapter 5
Modifying Your System
5.8 Preparing a Staging Area for Remote Distribution
120
c. Dismount the PowerPatch tape.
16. Mount write-enabled tape to create the CSLT. Reply to the tape request if needed.
a. AUTOINST updates temporary copies of the system libraries then creates the CSLT. This can take up to
2 hours.
The installer will next update staged copies of the
System SL, XL, and NL. . .
b. Monitor progress messages.
The update tool checks for disk space. If you receive an error message refer to Appendix H, “Error
Messages and Warnings,” and Appendix C, “Managing Disk Space,” for actions.
c. AUTOINST finishes creating the CSLT and displays:
Creating the CSLT ... done
Phase I of AUTOINST is now complete. Dismount and label the CSLT
AUTOINST CSLT HPVERSION v.uu.ff. Ensure that the write is now
DISABLED.
17. A warning message displays and lists manually installed products it cannot install, if applicable.
Record the product names that it cannot install on your checklist.
18. A warning message displays and lists data communications products that may require I/O configuration,
if applicable.
WARNING -- The following data communication products may
require I/O configuration changes. However, this will not
affect the software installation for these products.
(INSTWARN #3)
Record on the checklist the communication product names.
AUTOINST displays the following message that indicates that the CSLT is created:
To complete the installation, perform an Update from CSLT.
19. When the CSLT is created, dismount the CSLT, write-disable it, and label it with the v.uu.ff and
include the current date. You can find the SUBSYS v.uu.ff on the FOS, SLT, and/or SUBSYS tape labels.
You can find the PowerPatch v.uu.ff on the PowerPatch tape labels.
• Creating the CSLT Using AUTOINST completed. Go to the next section on your checklist.
5.8 Preparing a Staging Area for Remote Distribution
Perform the steps in this section only if you are planning to Distribute a Staging Area to a Remote system.
If you are performing a Manage Patch by Staging Area for only a Local system, skip sections 5.8 and 5.9, and
proceed to “5.10 Setting a Staging Area.”
NOTE You can only use the EXPORT and IMPORT commands of Stage/iX for applying patches to
systems that are on the identical base. Stage/iX will not verify whether or not your machines
are on the same base release.