HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

Appendix H 455
Error Messages and Warnings
Stage/iX Messages (STAGEMAN)
process).
1133 Message Failed to purge file “name” after staging it. CIERROR =
value (STAGEMAN 1133)
Cause STAGEMAN received a Command Interpreter (CI) error
in attempting to purge a file after it was staged.
Action Determine why the PURGE command failed, then purge the
file manually. There is no need to re-execute the command.
However, if this failure occurred during a run of Patch/iX,
the Patch/iX process may need to be restarted.
1134 Message Failed to do ALTFILE on file “name”. CIERROR = value
(STAGEMAN 1134)
Cause STAGEMAN received a Command Interpreter (CI) error
in attempting to perform an ALTFILE command on the file
to change its owner attribute.
Determine why the ALTFILE command failed. You can
either re-execute the command after the problem is fixed,
or just manually alter the owner with the ALTFILE CI
command.
1135 Message FROM file “name” does not exist. (STAGEMAN 1135)
Cause The file specified in the FROM parameter does not exist.
Action Determine why the file does not exist, correct the problem,
then re-execute the process. If this error occurred during a
run of Patch/iX, then contact your Hewlett-Packard
Response Center for assistance.
1136 Message FROM file “name” did not exist, but staged version did. No
move done. (STAGEMAN 1136)
Cause This warning is issued when STAGEMAN discovers that
the file specified in the FROM parameter does not exist,
but a version of the file does already exist in the staging
area. This is a normal occurrence when Patch/iX is using
STAGEMAN to stage files into a staging area while
Patch/iX is in recovery mode (for instance, if it previously
failed in the middle of staging files).
Action None
1137 Message Failed to set the ACD on file “name”.CIERROR = value
(STAGEMAN 1137)
Cause STAGEMAN received a Command Interpreter (CI) error
in attempting to do an ALTSEC command to replace the
current ACD on the staged file.
Action Contact your Hewlett-Packard Response Center for
assistance.
1138 Message Failed to open staged file “name”. (STAGEMAN 1138)