HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

Appendix H 421
Error Messages and Warnings
Installer Error Messages (INSTERR)
Cause The PowerPatch tape being installed includes patches that
are older than those that were included with the last
PowerPatch installation.
Action • Print the file HPSWINFO.PUB.SYS and refer to line 4
of the file to determine the V.U.F. of the last installed
PowerPatch tape. Compare this V.U.F. to the V.U.F. on
the tape label of the PowerPatch tape being installed.
• The V.U.F. from the tape label should indicate this
powerpatch tape as being older than the last installed
PowerPatch.
• Patches to be installed must come from a tape with a
V.U.F. at least equal to the last installed tape. Restart
the installation process from the beginning with the
appropriate tape.
• Contact your Response Center if further assistance is
required.
236 Message The files from the CSLT/STORE tape were not
successfully restored.
To continue with the installation, consult the
customer installation procedures.
(INSTERR #236)
Cause The JCW STOREJCW was nonzero after AUTOINST
executed the following STORE command to restore the
STORE files from the CSLT/STORE tape:
:RUN STORE.PUB;INFO= RESTORE &
CSLT;@.@.@;CREATE;SHOW=OFFLINE
Action • Ensure that a device with class LP is included in your
configuration.
• Use an appropriate text editor to inspect the offline
listing generated by the RESTORE. Identify the
spoolfile having RESTORE status by using the
command:
:LISTSPF SELEQ=[FILEDES=OFFLINE]
The last spoolfile displayed will contain the output
listing from the RESTORE command. The error messages
in this file will show the problems encountered in
restoring files from the CSLT/STORE tape. Following
are the types of errors that may occur:
— Out of disk space - There are two methods for
obtaining additional disk space:
• Use the ALTERVOL command in VOLUTIL to set
the permanent and transient space allocation
assignments to 100% on all system volumes