HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

Appendix H 399
Error Messages and Warnings
Installer Error Messages (INSTERR)
Cause The installer was attempting to build a workfile:
ASYSGNFL, and failed.
Action • Check and correct errors reported to terminal screen.
• Check for free disk space on system. There are two
methods for obtaining additional disk space:
• Use the ALTERVOL command in VOLUTIL to set the
permanent and transient space allocation assignments
to 100% on all system volumes except LDEV 1.
— Store user files to tape and them purge them.
Restore the files from tape at the end of the
installation.
— Take appropriate corrective measures and run the
installer again.
• Contact the Response Center if further assistance is
required.
147 Message The installer failed to STREAM the job indicated
as
Current IFILE in the HPINSTFL file. (INSTERR
#147)
Cause The COMMAND intrinsic returned a nonzero command
error when the installer attempted to stream an IFILE.
Action • Ensure there are no STREAM UDCs.
• Check the STREAMS and SPOOLER functionality by
streaming the indicated IFILE manually.
• Check the indicated IFILE for a valid JOB card.
• Take appropriate corrective measures and run the
installer again.
• Contact the Response Center if further assistance is
required.
148 Message Filename FREADLABEL failed. (INSTERR #148)
Cause Patch Selector failed while trying to read the user label on
the file.
Action For AUTOINST:
• The file filename may be corrupted. Restore it from the
PowerPatch tape.
• Run AUTOINST again. If unsuccessful a second time,
contact the Response Center for assistance.
For HPINSTAL:
• Restart HPINSTAL. It will restore files from the