HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

Appendix H 371
Error Messages and Warnings
Installer Error Messages (INSTERR)
installer again.
• Contact the Response Center if further assistance is
required.
50 Message An error occurred in translating the SL.
(INSTERR #50).
Cause OCT encountered an error in translating the SL.
The installer invoked OCT to translate newly installed
segments in the staged system SL. OCT encountered an
error and the installer trapped on the error condition.
Action • Print the file AUTOLOG.INSTALL.SYS to check OCT
error.
• Take appropriate corrective measures and run the
installer again.
• Contact the Response Center if further assistance is
required.
51 Message Error trying to RUN AUTOCM.INSTALL.SYS. (INSTERR
#51)
Cause Could not create AUTOCM process. Createprocess error:
status
• The CREATEPROCESS intrinsic returned an error
status when attempting to execute autocm_filename.
• Check the returned CREATEPROCESS error in the
MPE/iX Intrinsics Reference Manual.
• Print file AUTOLOG.INSTALL.SYS to check for
further errors.
• Ensure INSTALL group has sufficient capabilities.
(need CAP=PH).
• Take appropriate corrective measures and run the
installer again.
• Contact the Response Center if further assistance is
required.
52 Message An error occurred while modifying SL. (INSTERR
#52)
Cause AUTOCM.INSTALL.SYS encountered an error in
modifying the SL.
AUTOCM calls the SEGMENTER programmatically to
first delete segments in the staged system SL and then
adds new subsys or patched segments to the staged system
SL.
Action • Print the file AUTOLOG.INSTALL.SYS to ascertain