HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

364 AppendixH
Error Messages and Warnings
Installer Error Messages (INSTERR)
#28)
Cause The installer was unable to find information ona streamed
job. Either SUPACCT or one of the installation jobs failed
to produce a spool file for the installer to find or the
installer lost track of the JOB number. The location
number specified in the error message is a location
number within the installer code and should be included
with all communications with the Response Center.
Action • Ensure the spooler has been started on the LP device.
Start the spooler by entering:
:SPOOLER LP;START
:LISTF I???????.USL.SYS.
• If the file INDIRECT.USL.SYS exists, purge it.
• Determine the current job from the HPINSTFL file and
check the job's existence and/or termination. Use
SHOWJOB to find if the job is still running and
LISTSPF to find if there is a spoolfile.
• Take appropriate corrective measures, and run the
installer again.
• Contact the Response Center if further assistance is
required.
29 Message Unable to obtain CONSOLE LDEV#. (INSTERR #29)
Cause The installer assigns the value of the CI variable
HPCONSOLE to the JCW TMPJCW1 and then gets the
value of the JCW through the intrinsic FINDJCW. This
error results when FINDJCW returns an error status.
Action • Type SHOWJCW to determine whether the SETJCW
command succeeded.
• If TMPJCW1 does not display, attempt to set it
manually.
• If TMPJCW1 cannot be set manually, log on again:
:HELLO MANAGER.SYS,INSTALL;HIPRI
• Take appropriate corrective measures, and run the
installer again.
• Contact the Response Center if further assistance is
required.
30 Message The installer failed to create the AUTOPSTR
process (INSTERR #30)
Cause Occurs in AUTOINST only: The CREATEPROCESS
intrinsic returned an error status when attempting to
execute AUTOPSTR.INSTALL.SYS. Either the program