HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

356 AppendixH
Error Messages and Warnings
Installer Error Messages (INSTERR)
encountered a DDS firmware problem. Contact your
HP representative for further assistance.
• Take appropriate corrective measures, and run the
installer again.
• Contact the Response Center if further assistance is
required.
6 Message 6 Not used
7 Message The files from the POWERPATCH tape were not
successfully restored. To continue with the
installation, consult the customer installation
procedures. (INSTERR #7)
Cause The JCW STOREJCW was nonzero after the installer
executed the following STORE command to restore the
PowerPatch tape:
:RUN STORE.PUB;INFO= RESTORE &
PWRPATCH;!TMPSTR01;CREATE;SHOW=OFFLINE
Action • Ensure that a device with class LP is included in your
configuration.
• Use an appropriate text editor to inspect the offline
listing generated by RESTORE. Identify the spoolfile
having RESTORE status by using the command:
:LISTSPF SELEQ=[FILEDES=OFFLINE]
The last spoolfile displayed will contain the output
listing from the RESTORE command. The error messages
in this file will show the problems encountered in
restoring files from the PowerPatch tape.
• Missing files - Manually RESTORE missing files from
the PowerPatch tape. If successful, this indicates there
were transmission errors.
• Ensure that the RESTORE files are not being accessed
by another process.
• Out of disk space - There are two methods for obtaining
additional disk space:
— Use the ALTERVOL command in VOLUTIL to set the
permanent and transient space allocation
assignments to 100% on all system volumes except
LDEV 1.
— Store user files to tape and them purge them.
Restore the files from tape at the end of the
installation.
• Transmission errors - Clean tape heads and check for
hardware errors.