HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

Appendix H 351
Error Messages and Warnings
SETUP Error Messages (SETERR)
35 Message 35 Not used
36 Message Unable to purge the account mpe_hpslt. (SETERR
#36)
Cause SETINIT failed when attempting to purge the account
mpe_hpslt.
Action • Ensure that no files are open in the account.
• Purge the account from your terminal.
• Execute SETINIT.INSTALL.
• Contact the Response Center if further assistance is
required.
37 Message Unable to purge the account mpe_hpupdate.
(SETERR #37)
Cause SETINIT failed when attempting to purge the account
mpe_hpupdate.
Action • Ensure that no files are open in the account.
• Purge the account from your terminal.
• Execute SETINIT.INSTALL.
• Contact the Response Center if further assistance is
required.
38 Message Unable to purge the group mpe_cdgroup. (SETERR
#38)
Cause SETINIT failed when attempting to purge the group
mpe_cdgroup .SYS.
Action • Ensure that no files are open in the group.
• Purge the group from your terminal.
• Execute SETINIT.INSTALL.
• Contact the Response Center if further assistance is
required.
39 Message MPE release-dependent CI variables could not be
created. SETINIT
will terminate. (SETERR #39)
Cause SETINIT was unable to successfully execute the CI script
OLDACCTS to create the following MPE/iX
release-dependent variables: mpe_vol_1, mpe_vol_2,
mpe_hpslt, mpe_hpupdate, and MPE_cdgroup. SETINIT
examines these variables to determine the MPE/iX
software release version contained on the CD-ROM disks.
Action • Record any error messages preceding this message.
• Attempt to manually execute the OLDACCTS scripts