HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

344 AppendixH
Error Messages and Warnings
SETUP Error Messages (SETERR)
• Execute SETUP.INSTUTIL.
• If you have no other compact disks, contact the
Response Center for further assistance.
15 Message volname is not a valid volume set name. (“_” must
precede
the VUF and vol ID). (SETERR #15)
Cause The disk from which SETUP.INSTUTIL is executing is not
a valid Hewlett-Packard MPE-formatted compact disk.
Action • VSCLOSE the volume set containing
SETUP.INSTUTIL.
• Purgegroup INSTUTIL.
• Insert a compact disk with the appropriate label.
• VSOPEN the volume_set_name.
• Bind to the new volume: ALTGROUP
INSTUTIL.SYS;HOMEVS=VOLUME_SET.
• Execute SETUP.INSTUTIL.
• If you have no other compact disks, contact the
Response Center for further assistance.
16 Message volname is not a valid volume set name because of
the V.UU.FF.
(SETERR #16)
Cause The disk from which SETUP.INSTUTIL is executing is not
a valid Hewlett-Packard MPE-formatted compact disk.
Action • VSCLOSE the volume set containing
SETUP.INSTUTIL.
• Purgegroup INSTUTIL.
• Insert a compact disk with the appropriate label.
• VSOPEN the volume_set_name.
• Bind to the new volume: ALTGROUP
INSTUTIL.SYS;HOMEVS=VOLUME_SET.
• Execute SETUP.INSTUTIL.
• If you have no other compact disks, contact the
Response Center for further assistance.
17 Message SETINIT will terminate. (SETERR #17) From the
system console,
VSCLOSE mpe_volsetname. If this a SCSI drive,
run AVRSCSI.INSTALL
dismount ldev to take the disk offline.
Cause A CI error occurred during the SETINIT script while