HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

Appendix H 341
Error Messages and Warnings
SETUP Error Messages (SETERR)
• If GRPNAMES still has an invalid format, contact the
Response Center for further assistance.
7 Message GRPNAMES has an invalid format. This account has
no VOLUME
ID. SETUP will terminate. Follow the
instructions in your installation
manual to continue. (SETERR #7)
Cause The GRPNAMES data file on the compact disk has an
invalid format. The specific format of the file is a blank
line, followed by an account name, followed by the volume
set name on which the account resides, followed by the
groups within the account.
Action • Use the CI command LISTEQ to determine if a file
equation exists.
• If it exists, reset GRPNAMES.
• Execute SETUP.INSTUTIL.
• If GRPNAMES still an invalid format, contact the
Response Center for further assistance.
8 Message GRPNAMES has no groups for the specified
account. (SETERR #8)
Cause The GRPNAMES data file has an invalid format. An
existing account in GRPNAMES has no associated groups.
Action • Use the CI command LISTEQ to determine if a file
equation exists.
• If it exists, reset GRPNAMES.
• Execute SETINIT.INSTUTIL.
• If GRPNAMES still an invalid format, contact the
Response Center.
9 Message A specified account was not successfully
created. SETUP
will terminate. Follow the instructions in your
installation manual
to continue. (SETERR #9)
Cause One of the accounts in the GRPNAMES data file could not
be successfully created.
Action • Ensure that your log on, MANAGER.SYS,INSTALL
has all MPE capabilities.
• Ensure that no other process has accessed the account.
• If so, instruct the user to log off.
• Execute SETINIT.INSTALL.