HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

Appendix G 325
HP Stage/iX Reference
HP Stage/iX Commands
[;DISK={NONE}]
{CONTIG}
{LDEV1}
[;DISP={IGNORE}]
{REPLACE}
{ADD}
{DELETE}
[;ONERR={IGNORE}]
{WARN}
[;VAL={BASIC}]
{EXISTENCE}
{CHECKSUM}
[;VALINFO="validation_info"]
[;LIFTYPE={NONE} ]
{BOOT}
{IPL}
{DATA}
{AUTOF}
[;OWNER="owner_name"]
[;{MOVE}]
{COPY}
Parameters
[STAGE=]stage_name (Required)
The name of the HP Stage/iX staging area. This must exist, cannot be in use, and cannot
be the staging area designated for use on the next boot.
[FROM=]from_file_name (Required)
The name of the file in its current (pre-staged) location. This can be expressed in either
POSIX (HFS) or MPE syntax ((example: /SYS/PUB/NL and NL.PUB.SYS are equivalent).
[TO=]to_file_name (Required)
The final target name for the file. This must be expressed as a fully qualified filename. It
can be expressed in either POSIX (HFS) or MPE syntax (example: /SYS/PUB/NL and
NL.PUB.SYS are equivalent).
NOTE If the filename is expressed in POSIX syntax, but is expressible in MPE
syntax, the filename will be converted to MPE syntax. This is to avoid the
problem of the same file being stageable under two names.
[;DISK=disk_restrict] (Optional)
Values: CONTIG (C), LDEV1 (1), NONE(N)