HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

Appendix G 321
HP Stage/iX Reference
HP Stage/iX Commands
same staging area as was used on the previous reboot, unless the system manager changes
the default by using the SET command.
You must specify the name of a validated HP Stage/iX staging area to the SET command.
The SET command will accept the string “BASE” to indicate that the system should be
booted from the BASE on the next reboot.
The SET command cannot be abbreviated.
Syntax
SET [[STAGE=] stage_name ]
Parameters
[[STAGE=]stage_name (required)
The name of the HP Stage/iX staging area to be used for the SET. This must be a legal
staging area name for a pre-existing staging area.
Staging area names are case sensitive. “STAGE1” is not equivalent to “stage1” or “Stage1”.
Example
STAGEMAN> SET STAGE=new_staging_area
SETDEFAULT (SETD)
The SETDEFAULT command sets the default values for a particular file to be used by the
STAGEFILE command. For example: the SETDEFAULT command can be used to the set the
defaults for NL.PUB.SYS, so that whenever an NL is staged using the STAGEFILE command,
the values for all of the STAGEFILE parameters can be omitted.
There is a file, STAGEDEF.PUB.SYS, that contains all of the default values for files that
make up HP software products. This file contains multiple SETDEFAULT commands. The
STAGEDEF file is implicitly executed whenever STAGEMAN is run.
The SETDEFAULT command can be abbreviated as SETD.
Expert Mode Command:
Syntax
SETDEFAULT [FILE=] file_name
[;DISK={ NONE}]
{CONTIG}
{ LDEV1}
[;DISP={ IGNORE}]
{REPLACE}
{ ADD}
{ DELETE}
[;ONERR={IGNORE}]
{ WARN}