HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

224 AppendixD
Backdating Your System
Performing the Backdate
2. Enter Y to the Interact
with IPL? prompt, if it appears on your screen.
The system boots from tape. After some activity the ISL prompt displays.
5. Check FASTSIZE value:
ISL>DISPLAY
If the value is not F, then change it to F:
ISL>FASTSIZE F
If you changed the FASTSIZE value:
a. Reset the system again to set the new Fastsize value.
b. Reboot from the alternate boot path.
6. Update the system with the factory SLT.
ISL>UPDATE
7. Confirm the date and time.
8. Boot the system from the primary boot path.
1. Boot messages can vary, respond as appropriate depending on the system model.
2. Enter Y to the Interact
with IPL? prompt, if it appears on your screen.
The system boots from disk. After some activity the ISL prompt displays.
Listing System Configuration
Listing the system configuration uses the off-line diagnostic tool, Mapper. To get help using
Mapper, type help at the mapper prompt. Refer to “Listing the System Configuration” in
Chapter 5 , “Modifying Your System,” for additional information about these steps.
To list the system configuration:
1. Check that all hardware peripherals are attached and powered on.
2. Start ODE.
ISL>ODE
3. Display hardware configuration.
ODE>RUN MAPPER
ODE>RUN MAPPER2 For N-Class and A-Class systems
4. Record I/O configuration.
Note the MPE/XL Model String: value. Refer to Appendix B , “Configuration Tables,” for
the configuration group name.
5. Exit mapper.
ODE>EXIT