HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

Appendix A 193

Manually Installed Products

Conﬁguring HP Predictive Support

NOTE

The job JPSMON.PRED.SYS needs to be running or Predictive Support will

not perform its daily scheduled run to monitor your system.

The directions in this section only describes how to update an existing version of HP

Predictive Support.

To conﬁgure HP Predictive Support for the ﬁrst time, please contact your Hewlett-Packard

Customer Engineer who will do the initial conﬁguration and provide the HP Predictive

Support User’s Guide and the HP Predictive Support User’s Guide Addendum.

To update HP Predictive Support:

After updating your system, you must start the HP Predictive Support run to ensure a

complete update.

1. Log on as MANAGER of the SYS account.

:HELLO MANAGER.SYS;HIPRI

2. Run HP Predictive Support’s user interface (PSCONFIG).

:RUN PSCONFIG.PRED;INFO= “RUN”

3. Review the Action Summary Report that may be generated by the run for any actions

you must take.

You may need to run PSCONFIG and enter coverage information for newly supported or

additional devices. This run of HP Predictive Support automatically includes data

transfer to the Response Center, as required.

For detailed information on conﬁguring HP Predictive Support, see the HP Predictive

Support User’s Guide. For information on HP Predictive Support enhancements for

MPE/iX 7.0, see the HP Predictive Support User’s Guide Addendum.