HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

Chapter 5 143
Modifying Your System
5.16 Rerunning HPINSTAL
3 Create a CSLT for another system
4 Create a CSLT with PowerPatch patches for another system
5 Complete the update of this system using a CSLT created on
another system
6 Add SUBSYS products to this system
7 Add SUBSYS products and install patches from a Powerpatch
tape
Enter your choice >>5
Go to Step 8.
8. Restore the STORE portion of the CSLT.
Mount the CSLT tape and put the tape drive online. If using DDS tape, remove the tape
and reinsert it now.
Mount the CSLT and put the tape drive ONLINE.
Skipping system files...
The HP-supported software files will be restored.
The system then restores files, processes STORE files, creates the accounting structure,
and processes installation files.
FILES RESTORED.
The SUBSYS tape has been successfully restored.
Processing STORE Files . . .
DONE
DONE
The time it takes to restore the software files varies depending on which specific
subsystems you have on your system.
9. Follow any additional instructions displayed on the screen. Reply to tape requests, if
necessary.
When HPINSTAL finishes the task, you will see the following message:
The installation is now complete.
10.Install products that cannot be installed automatically.
Refer to the list of products in Appendix A , “Manually Installed Products,” and follow
the directions on installing these products.
• Rerunning HPINSTAL completed. Go to the next section on your checklist.