HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

142 Chapter5

Modifying Your System

5.16 Rerunning HPINSTAL

To rerun hpinstal and ﬁnish applying the CSLT:

1. Remount the CSLT created by HPINSTAL.

2. Reinvoke HPINSTAL and resume previous installation.

:HPINSTAL

3. If you are performing an Add-on or Update task, go to Step 4.

If you are performing a Modify Remote System task, go to Step 5.

Add-on Tasks, Update Tasks

4. Resume previous installation.

a. Type YES at the prompt.

If the CSLT was created on the system you are updating, the system displays a

message saying it located an old audit trail of an incomplete installation (that is,

HPINSTFL.INSTALL.SYS). You must respond YES and resume the installation to

complete the task.

b. Go to Step 5.

However, if you accidentally responded NO, you can continue by performing the

following:

a. Exit hpinstal by selecting Option 8.

b. Reinvoke HPINSTAL using the recovery parameter:

:HPINSTAL RECOVERY

c. Go to Step 5.

5. If you are applying a CSLT to a Remote system, go to Step 6.

If you are performing an Add-on or Update task for the local system only, go to Step 8.

Remote Tasks

6. Deny any previous installation, if it exists.

Type NO at the prompt.

If you are modifying a remote system (the CSLT was created on a local system) and the

following message displays, it indicates that HPINSTAL located an old audit trail of an

incomplete installation (that is, HPINSTFL.INSTALL.SYS). You must respond NO to

properly complete your remote installation task.

7. From the HPINSTAL menu, select option 5, “Complete the update of this system using a

CSLT created on another system,” to start the update process on the remote system.

1 Update this system

2 Update this system and install patches from a PowerPatch tape