HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

Chapter 5 135
Modifying Your System
5.13 Applying the CSLT Modification
e. Enter Y to confirm restarting the system.
5. Boot the system from the alternate boot path where the CSLT is mounted.
a. Boot messages can vary, depending on the system model.
• If you do not override AUTOBOOT, the system boots from the primary boot path. If
your system does boot from the primary boot path, return to Step 3 and reset the
system with the CTRL-B and RS commands.
• If your system prompts Continue with primary boot path?,orBoot from
Primary Boot (y/n)?, enter N.
If your system prompts Continue with alternate boot
path? or Boot from Alternate Boot
(y/n)?, enter Y.
• If your system prompts to enter the boot path, enter the alternate boot path.
• For Model 9x8LX, 9x8RX, 9x9KS, N-Class or A-Class systems, type BO
ALT at the PDC screen to boot from the alternate boot path.
b. Enter Y to the Interact with IPL? prompt, if it appears on your screen.
The system boots from the alternate source (tape). After some tape activity, the ISL
prompt displays.
6. If this is a new system, check FASTSIZE value.
ISL>DISPLAY
Fastsize value is 0000000 n
. . .
If the value ( n ) is F, then go to Step 8.
If the value (
n ) is not F:
a. Change it to F.
ISL>FASTSIZE F
b. Return to Step 3 again to set the new FASTSIZE value.
7. If you replace LDEV 1 and changed the primary boot path of the new LDEV 1, update
the primary boot path:
ISL>PRIMPATH
Enter primary boot path: hardware_path
Where hardware_path is the path to your new LDEV 1.
8. If you are performing Manage Patch, Add-on, Update, Remote, or Install tasks, go to
Step 9.
If you are performing a Reinstall task only, go to Step 10.
Manage Patch, Add-on, Update, Remote, or Install Tasks
9. Modify the system with the CSLT.
a. If you have AUTOBOOT enabled, turn AUTOBOOT OFF.