HP e3000 MPE/iX Release 7.0 System Software Maintenance Manual (30216-90317)

122 Chapter5
Modifying Your System
5.7 Creating the CSLT Using AUTOINST
Disk Space,” for actions.
b. When you find the required disk space, run AUTOINST again.
7. Select the option that matches your task.
:run autoinst
MPE/iX AUTOINST E.11.02 (C) HEWLETT-PACKARD CO.
Please choose and enter the number corresponding to the software
you want to install.
1 PowerPatch
2 SUBSYS (Add-On) and PowerPatch
3 FOS, SUBSYS, PowerPatch
4 FOS and SUBSYS
5 Add-On (SUBSYS only)
6 Exit
Enter your choice_
8. Reply to the prompt for LDEV number.
Press
[Return] to use the default device class TAPE or enter the LDEV number of the
device where you want the Customized System Load Tape (CSLT) to be created. The
device you specify applies to all tape requests.
CAUTION Failure to specify a valid tape LDEV number will result in a program hang
while writing to tape. If this occurs, a tape request will keep reappearing and
will not take the specified LDEV number as input.
The file equation from the tape device, which is used to
restore files and create the CSLT, defaults to `DEV=TAPE'.
If you prefer to designate a different device, enter its
LDEV number now (RETURN for default)>> _
9. If you are performing an Update or Install task, go to Step 10.
If you are performing an Add-on, go to Step 11.
Update and Install Tasks
10.Restore FOS files.
This step takes about 20–45 minutes.
a. Mount FOS tape and reply to tape request when the following message displays.
Mount the FOS tape and put the tape drive online. The
files from the FOS tape will now be restored.
b. Dismount the FOS tape when the restore complete message displays.
The files from the FOS tape were successfully restored.
11.Respond to the SUBSYS prompt: