HP e3000 Fibre Channel Mass Storage Adapters Service and User Manual (32650-90910)

Chapter 4

Troubleshooting

Diagnostic Flowcharts

The diagnostic flowcharts provide the following tests:

• Flowchart 1: Boot Test. Verifies that the system boots correctly over Fibre Channel.

• Flowchart 2: Configuration Test. Verifies the configuration of the mass storage interface on a host

using the FCSCAN utility.

• Flowchart 3: Fibre Channel Connections Test. Checks that all the hardware connections between

the system and the Fibre Channel mass storage devices are connected and operational.

Figure 4-1 Flowchart 1: Boot Test

Flowchart 1 Procedures

A. Is the system bootable over the Fibre Channel? Only certain systems can boot over the Fibre

Channel adapter. If your system is not capable, you must boot from a SCSI device.