HP Data Entry and Forms Management System (VPLUS) Reference Manual (32209-90024)

Appendix B 505
VPLUS Error Messages
FORMSPEC Error Messages
Init and Compile Messages
Error Message Cause/Action
902
For form !, the next form ! has
not been defined.
The next form name specified does not exist in
the forms file. Change the next form name or
create a form with that name.
903
The head form ! has not been
defined.
The head form specified on the globals menu
does not exist in the forms file. Create a form
with the head form name or change the head
form on the globals menu.
904
Internal error closing FORMSPEC
forms file. (COM’STATUS !!!!)
905
Internal error closing the
terminal file. (COM’STATUS !!!!)
909
Error writing the global code
record. File full? (FSERR !!!!)
See error 123.
911
Error writing form code record
for form !. File full?
(FSERR !!!)
See error 123.
912
Internal error reading screen
source for form !. (FSERR !!!)
913
Internal error closing your forms
file. (FSERR !!!!)
915
Initial value contains system
constant,
916
In form !, the field name ! is
not unique.
Duplicate field name found in indicated form;
use FIELD menu to change field name.
917
Error writing field names table
for form !. File full? (FSERR
!!!)
918
Error writing save field table
for form !. File full? (FSERR
!!!)
See error 123.
919
The initial value is too long.
The initial value is longer than the length of
the field as defined on the screen menu. Use
the screen menu to lengthen the field or
shorten the initial value on the field menu.
920
The initial value contains an
invalid DIG value.
A DIG type field may contain only digits (0-9),
no decimal point, commas, or sign.
921
The initial value contains an
invalid NUM value.
A NUM type field may contain only digits,
decimal point, a sign.
922
The initial value contains an
invalid numeric value.
This field may only have a numeric value; no
letters or special characters.