HP Data Entry and Forms Management System (VPLUS) Reference Manual (32209-90024)
122 Chapter3
INTRODUCTION TO FORMS DESIGN
DATA CAPTURE DEVICE SPECIFICATIONS MENU
OR Wait for user to press ENTER You may also specify that screen presentations
for messages longer than 24 (or 32) characters be displayed after
ENTER is
pressed. Enter a YES in this box and a zero (0) in the Split Message
Pause box. This field does not apply to Mini-CRT display.
Default NO
Error Light You may specify which keyboard light is to be lit if an error is detected on
the form by the application or by VPLUS. This light will remain lit during
the re-presentation of the form. You may specify any one of the following:
@, A through P.
Default E
Multifunction Reader: If you select the Multifunction Reader as an input device, you
can specify how it should be configured to accept valid card and badge
input. The following options are available:
HOLES/MARKS The card or badge will have holes or will be mark sensed.
Default HOLES
Corner Cut Required The card or badge must be presented with the
corner in accordance with the diagram on the terminal.
Default YES
Clock On/After /NONE The card or badge will have clock marks after
each column of data, or no clock marks. Valid input is CAD
(clock after data) or NONE (no clocking).
Default NONE
Invalid combinations of the above are Holes with Clock On data and
Marks with NONE.
Bar Code Reader If you select the Bar Code Reader as an input device, you can specify
how it should be configured. The following options are available:
Format You can specify which bar code format will be read. Choose
one of the following:
• UPC — Universal Product Code
• I25 — Industrial 2 out of 5
• MAT — INTERMEC 2 out of 5 MATRIX code
• 139 — INTERMEC code 39 alphanumeric bar code
• EAN — European Article Numbering
• ILV — Interleaved 2 out of 5
Default UPC
code I39 is a registered trademark of Interface
Mechanism, Inc.
Disable Check Digit When you specify the bar code reader as an input
device, VPLUS configures the device to require check