HP ARPA File Transfer Protocol User's Guide (36957-90159)

Appendix B 89
Error Messages
FTP User Messages and Errors
(FTPERR 32) MESSAGE: Remote server received timeout. Closing connection.
CAUSE: The FTP user did not receive a required reply from an FTP server in the allocated
time window.
ACTION: Close the connection and quit before trying again. Try to ping the remote system
using PING.NET.SYS. If this does not succeed, no FTP connection can be established.
Follow the troubleshooting instructions in the Installing and Managing HP ARPA File
Transfer Protocol Network Manager’s Guide.
(FTPINFO 33) MESSAGE: ExitOnError mode on.
CAUSE: The EXITONERROR command was entered while the exit-on-error feature was
disabled.
ACTION: None.
(FTPINFO 34) MESSAGE: ExitOnError mode off.
CAUSE: The EXITONERROR command was entered while the exit-on-error feature was
enabled.
ACTION: None.
(FTPERR 35) MESSAGE: Invalid IP address.
CAUSE: An invalid IP address was used while trying to open a connection.
ACTION: Refer to the body of this manual for assistance.
(FTPWARN 36) MESSAGE: Performing an ASCII transfer to a binary file.
CAUSE: An ASCII data transfer occurred to an MPE/iX binary file.
ACTION: If the intent was to transfer binary data, then use the BINARY command to change
transfer mode to binary. If the intent was to transfer ASCII data, then specify an MPE/iX
ASCII file using the appropriate MPE/iX BUILD parameter.
(FTPWARN 37) MESSAGE: Performing a binary transfer to a binary file.
CAUSE: A Binary data transfer occurred to an MPE/iX ASCII file.
ACTION: If intent was to transfer ASCII data, then use the ASCII command to change
transfer mode to ASCII. If the intent was to transfer binary data, then specify an MPE/iX
binary file using the appropriate MPE/iX BUILD parameter. Refer to the HP ARPA File
Transfer Protocol User’s Guide for further assistance.
(FTPERR 38) MESSAGE: Error opening data connection.
CAUSE: Internal Error. An I/O completion was received for an unknown file number during
the attempted establishment of a data connection.
ACTION: Note the circumstances and seek the assistance of your Hewlett-Packard
representative.
(FTPERR 39) MESSAGE: ?Ambiguous command.
CAUSE: A non-unique command string was entered at the ftp> prompt.
ACTION: Check the command spelling and try again.
(FTPINFO 40) MESSAGE: Connected to !.