High Availability FailOver/iX Manual (32650-90911)

Appendix-B

If the HAFO primary and SYSGEN (io) paths are in sync and all HAFO Ldevs

are operating on their primary paths, then call your HP Support Representative

for assistance.

1012 MESSAGE: HAFO INTERNAL ERROR — (HAFOERR 1012)

CAUSE: Failover failed — Volume label verification failed.

ACTION: Check to make sure that there are no mismatches between the

SYSGEN (io) section configuration and the HAFO (ha) section configuration

All HAFO (ha) configured primary paths must match the SYSGEN (io) path

configuration for all HAFO Ldevs.

Check that there are no hardware problems and make sure no failover events

have occurred. If a failover event has occurred, fix the primary path and make

sure all HAFO Ldevs are operating on their primary path.

If the HAFO primary and SYSGEN (io) paths are in sync and all HAFO Ldevs

are operating on their primary paths, then call your HP Support Representative

for assistance.

1013 MESSAGE: HAFO INTERNAL ERROR — (HAFOERR 1013)

CAUSE: Failover failed — Mounted Volume Table inconsistent.

ACTION: Check to make sure that there are no mismatches between the

SYSGEN (io) section configuration and the HAFO (ha) section configuration.

All HAFO (ha) configured primary paths must match the SYSGEN (io) path

configuration for all HAFO Ldevs.

Check that there are no hardware problems and make sure no failover events

have occurred. If a failover event has occurred, fix the primary path and make

sure all HAFO Ldevs are operating on their primary path.

If the HAFO primary and SYSGEN (io) paths are in sync and all HAFO Ldevs

are operating on their primary paths, then call your HP Support Representative

for assistance.

1014 MESSAGE: HAFO INTERNAL ERROR — (HAFOERR 1014)

CAUSE: The Device Manager is in the wrong state for the command being

executed.

ACTION: Check to make sure that there are no mismatches between the

SYSGEN (io) section configuration and the HAFO (ha) section configuration.

All HAFO (ha) configured primary paths must match the SYSGEN (io) path

configuration for all HAFO Ldevs.