Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90057)
Configuring Serial Devices (for PC-Based Management)
Modify the Network Management Configuration File
Chapter 6
98
5. Press the
[Config Card]
function key. The corresponding screen for the card number
entered in the last step will be displayed.
6. If all the cards with nailed ports have been configured, press the
[Prior Screen]
key to
return to the DTC Configuration Selection screen to select another DTC with nailed
ports to configure. Otherwise, if every DTC has been configured, press the
[Validate DTS/LINK]
key to validate the configuration file.
Configure a X.25 Card
When a X.25 card is configured using PC-based management, you can use the screen in
Figure 6-7 to configure nailed PAD devices. The screen is only available for a DTC 48,
DTC 16 and DTC 72MX.
NOTE Also refer to Using HP OpenView DTC Manager for all other X.25 and PAD configuration
information.
Figure 6-7 DTC X.25 Card Configuration Screen
1. Verify that the “DTC name” and “Card number” displayed are correct.
2. Use the
[TAB]
key to move the cursor to the desired fields. Enter the ldev number,
profile and device name in the fields on the screen for nailed device.
Ldev numbers used for each port on all DTCs must be unique. Up to 4649 terminal
I/O devices may be configured on the HP 3000 Series 900. The largest valid ldev
number is 4679.