Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90057)
Configuring Serial Devices (for PC-Based Management)
Modify the Network Management Configuration File
Chapter 6
96
If you are configuring a direct or modem connect card the
[Config Card]
key will go to
the screen described in the subsection Configure a Direct Connect Card. If you are
configuring a X.25 card the
[Config Card]
key will go to the screen described in the
subsection Configure a X.25 Card.
To configure the ports on a DTC 16iX/16MX/16RX, simply press the
[Config Ports]
function key. Proceed to step 7: Configure DTC Cards.
6. Repeat steps 1 through 5 above for every newly-added DTC with nailed devices that
will be accessed by this HP e3000 computer. If you want to select a DTC that has
already been configured, enter the DTC’s name in the DTC name field and press the
[Read DTC]
function key.
NOTE You may use the
[Tune DTC]
key on the DTC Configuration Screen to change the AFCP
timers for the DTC, if needed. Refer to Chapter 8, “ Additional DTC Configuration,” for
steps to do this.
Step 7: Configure DTC Cards
When you press the
[Config Card]
key at the DTC Configuration screen, NMMGR will
display the corresponding card configuration screen for the specified card in the DTC.
Figure 6-6 shows an example of a Direct Connect Card Configuration screen for
DTC 72MX. (Screens for DTC 16iX/16MX/16RX, DTC 16 and DT C48 vary slightly.)
Figure 6-7 shows the screen for configuring nailed PAD devices on a X.25 card.
NOTE You only need to configure nailed ports (such as printer ports) in the DTC. If you do not
have nailed ports on a card, you can skip this step.