Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90057)

Configuring Serial Devices (for PC-Based Management)
Modify the Network Management Configuration File
Chapter 6
92
Step 4: Configure the Link
The Host Configuration screen is displayed when you press the
[DTS]
key at the Main
screen (Figure 6-3).
Figure 6-3 Host Configuration Screen (PC-Based)
1. “Local HP e3000 node name” is a display-only field. Verify that it is correct.
2. Use the default link name, DTSLINK.
3. Enter the slot number of the LANIC in the “Physical path of LANIC” field. See
Chapter 2, “Preparing to Configure DTCs,” for a list of suggested slot numbers to
use.
4. Enter the desired number of non-nailed terminals to be allowed on the HP 3000.
Currently, NMMGR allows the configuration of up to 4649 terminal I/O devices.
5. Enter the ldev number where the non-nailed pool should start. The non-nailed
devices will be configured on ldevs with the starting ldev number and higher.
For example if the number of ldevs is 2 and the starting number is 200 then the
non-nailed ldev would be 200 and 201. If 201 is already configured as a nailed device
then the non-nailed device would be 200 and 202.
6. Enter the profile to use for the non-nailed terminals.