Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90057)
Configuring Serial Devices (for PC-Based Management)
Modify the Network Management Configuration File
Chapter 6
90
Modify the Network Management Configuration File
Use NMMGR to enter asynchronous device connection information into the Network
Management Configuration File NMCONFIG.PUB.SYS. The procedure for updating the
configuration file follows.
Step 1. Begin the Configuration Process
To run NMMGR, enter the following command at the MPE/iX prompt and then press the
[Return]
key.
NMMGR.PUB.SYS
NOTE You must be logged on to the SYS account to run NMMGR.
Step 2: Open the Network Management Configuration File
Invoke NMMGR, the Open Configuration/Directory File screen as shown in Figur e6-1,
allows you to specify the configuration file name.
Figure 6-1 Open configuration/Directory Screen
1. Use the default configuration file name, NMCONFIG.PUB.SYS.
2. Enter a backup configuration file name. The default is NMCBACK.PUB.SYS.