Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90057)

Dynamic Configuration and DTS Shutdown/Restart

Performing a Dynamic Configuration

Chapter 4

Dynamic Configuration Status

You can also use DTCCNTRL to check the status of the last dynamic configuration. To see

the status of the last dynamic configuration, type the DTCCNTRL command at the CI

prompt either without specifying the desired operation or by specifying it using the

syntax outlined below:

• View status operation not specified:

• View status operation specified:

:DTCCNTRL func=dcstatus

If there were no errors from the last dynamic configuration performed by invoking

DTCCNTRL, you will see the message “No errors from last DTS dynamic

configuration.” If errors occurred during the last dynamic configuration, you will

see the message “Errors occurred from the last DTS dynamic

configuration. See LOGDCC.PUB.SYS for error detail.” Refer to the previous

section in this chapter, “LOGDCC and LOGDCCBK Files,” for more information on

the LOGDCC file.

:DTCCNTRL

0 exit

1 dynamically implement DTS changes made in NMMGR

2 view status of last DTS dynamic configuration

3 automatically add a new DTC

4 shutdown DTS subsystem

5 restart DTS subsystem

6 manage/dynamically configure host-based x.25

7 help

For help on these topics, select 7 at the prompt below.

Select one of the numbers above corresponding to the desired

operation: 2