Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90057)

Automatic Configuration of DTCs
Performing an Automatic Configuration Inside NMMGR
Chapter 3
49
Step 2: Activate Automatic Configuration Process
The DTC Configuration Selection Screen (Figur e3-1) is displayed when you press the
[Go to DTC]
key at the Host Configuration Screen. Here you can access the DTC
Automatic Configuration Screen and activate the automatic configuration process.
Figure 3-1 DTC Configuration Selection Screen
Follow the steps listed here to enter data for this screen.
1. In the “Automatically add/configure a new DTC (Y/N)?” field, enter a Y and
press the
[Enter]
key.
2. The DTC Automatic Configuration Screen will appear.