Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90057)

Automatic Configuration of DTCs
Chapter 3
45
3 Automatic Configuration of DTCs
This chapter describes how you can add and configure a new host-based managed DTC
to the HP e3000 system without needing to specify detailed configuration information
such as DTC cards/boards and ldevs (herein referred to as automatic configuration).
You can perform an automatic configuration by using a command file that is activated
either outside or inside the NMMGR utility. You may choose to add a DTC automatically
inside NMMGR if you need to make other DTS configuration changes. These two
methods are described below.
NOTE If you want to dynamically implement DTS changes made in NMMGR (dynamic
configuration) or perform a DTS shutdown or restart, refer to Chapter 4, “Dynamic
Configuration and DTS Shutdown/Restart.” If you want to manage/dynamically
configure host-based X.25 links, refer to the Configuring and Managing Host-Based X.25
Links manual.