Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90057)

Error Messages
DCC Error Messages
Appendix E
235
Action: Check that the file exists and that it is not locked. If the file exists and is not
locked, check for file system or hardware problems.
(DCCWARN 102) DCC WARNING P-L, (Startup) can not purge NMCONFIX, status SSSSSSSS.
Cause: The NMCONFIX.PUB.SYS file cannot be purged.
Action: Check that the file exists. If the file exists, check for file system or hardware
problems.
(DCCWARN 103) DCC WARNING P-L, (Startup) can not open NMCONFIX, status SSSSSSSS.
Cause: The NMCONFIX.PUB.SYS file exists but it cannot be opened.
Action: Check that the file is not locked. If the file is not locked, check for file system or
hardware problems.
(DCCWARN 104) DCC WARNING P-L, (Startup) can not create NMCONFIX, status SSSSSSSS.
Cause: A disk space problem, a file system problem, or a hardware problem exists.
Action: Verify that enough disk space is available. If enough disk space is available,
verify that no file system problems exist. Then, verify that no hardware problems exist.
(DCCWARN 105) DCC WARNING P-L, (Startup) can not copy record from NMCONFIX, status
SSSSSSSS.
Cause: The NMCONFIX.PUB.SYS does not exist, or a file system or hardware problem
exists.
Action: Check that the NMCONFIX.PUB.SYS file exists. If it does not, restore it. If the file
exists, check for file system or hardware problems.
(DCCWARN 106) DCC WARNING P-L, (Startup) can not copy record to NMCONFIG, status SSSSSSSS.
Cause: The NMCONFIG.PUB.SYS file does not exist, or a file system or hardware problem
exists.
Action: If the file does not exist, create it. If the file exists, check for file system or
hardware problems.
(DCCWARN 107) DCC WARNING P-L, (Startup) can not close NMCONFIG, status SSSSSSSS.
Cause: The NMCONFIG.PUB.SYS file does not exist, or a disk space, a file system, or
hardware problem exists.
Action: Check that the NMCONFIG.PUB.SYS file exists. If it does not exist, restore it. If
the file exists, check for a disk space problem, a file system problem, or a hardware
problem.
(DCCWARN 108) DCC WARNING P-L, (Startup) can not close NMCONFIX, status SSSSSSSS.
Cause: The NMCONFIX.PUB.SYS file does not exist, or a disk space, file system, or
hardware problem exists.
Action: Check that the NMCONFIX.PUB.SYS exists. If it does not exist, restore it. If the
file exists, check for a file system problem or a hardware problem.