Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90057)

Error Messages
Validation Error Messages
Appendix E
226
Cause: The configuration for the DTC specified in NMMGRpath has been corrupted.
Action: Delete the DTC specified in NMMGRpath and re-enter the data for this DTC.
(DTSERR 84) Path: NMMGRpath — Cardtype for card c does not match DTC card configuration.
Cause: The configuration for the DTC specified in NMMGRpath has been corrupted.
Action: Delete the DTC specified in NMMGRpath and re-enter the data for this DTC.
(DTSERR 85) Path: NMMGRpath — Cardtype configured on card c not allowed on dtctype.
Cause: The configuration for the DTC specified in NMMGRpath has been corrupted.
Action: Delete the DTC specified in NMMGRpath and re-enter the data for this DTC.
(DTSERR 86) Path: NMMGRpath — Ldev #nnn> is not valid (must be >= -l and <=4679).
Cause: The logical device (ldev) number is outside the allowed range.
Action: Go to the screen specified in NMMGRpath and modify the ldev number.
(DTSERR 87) Path: NMMGRpath —Non-nailed Ldev of -1 is not allowed with printer profile.
Cause: An ldev number of -l has been specified on a port that has a profile configured
that is of type terminal or printer.
Action: Go to the screen specified in NMMGRpath and change the ldev or specify a
profile that is a type HOST.
(DTSERR 88) Path: NMMGRpath — Profile for ldev #nnn, <profname>, is of HOST type.
Cause: Profile <profname> is of type HOST and has been configured on a DTC port where
ldev specified is not -l.
Action: Ports using HOST profiles are for back-to-back and must have an ldev of -l. Go to
the screen specified in NMMGRpath and change the ldev to -l or use a different profile
that is not of type HOST.
(DTSERR 89) Path: NMMGRpath — Too few non-nailed ldevs available above TIO start ldev.
Cause: There are not enough ldevs available above the TIO start ldev number to
configure the number of ldev specified.
Action: Lower the number of TIO non-nailed ldevs or delete all TIO non- nailed ldevs
and specify a lower starting ldev number. Then add the desired number of ldevs.
(DTSERR 90) Path: NMMGRpath — Too few non-nailed ldevs available above PAD start ldev.
Cause: There are not enough ldevs available above the PAD start ldev number to
configure the number of ldev specified.
Action: Lower the number of PAD non-nailed ldevs or delete all PAD non- nailed ldevs
and specify a lower starting ldev number. Then add the desired number of ldevs.
(DTSERR 92) Path: NMMGRpath — Attached device for LDEV#nnn, defined in Profile <profilename>,
is not supported on DTC 16 and DTC 48.
Cause: Modem devices configured (either US inout modem or European inout modem)
are not supported on DTC16 or DTC48.
Action: Go to DTC specified in NMMGRpath and change the modem type to required
modem type other than US inout or European inout.
(DTSERR 93) Path: NMMGRpath —Eight bit with parity for LDEV #nnn, defined in Profile
(profilename>, is not supported on DTC16 and DTC48.