Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90057)

Additional DTC Configuration
Configuring SNMP
Chapter 8
153
Configuring Trap Destinations
To specify the SNMP managers that will receive any SNMP error messages generated by
the DTC, access the SNMP Trap. Destination Configuration screen. This screen can be
accessed by pressing the
[Go To Trap]
key at the SNMP MIB Configuration screen or
SNMP Authorization Filter Configuration screen.
The SNMP Trap Destination Configuration screen for host-based management is shown
in Figure 8-6. You can configure up to ten IP addresses for trap destinations.
Figure 8-6 SNMP Trap Destination Screen
The “DTC Name” field is a read-only field which indicates the SNMP configuration is for
that specific DTC.
1. Enter the IP address of the SNMP manager in the “IP Address” field.
The IP address must be a valid individual IP address; the global definition of IP
addresses, “*.*.*.*” or “@.@.@.@”, is not valid for this screen.
Note: Only DTC MIBs can send error trap information. Make sure that all IP
addresses entered have MIB View = “1” (see SNMP Authorization Filter
Configuration screen).
2. After you have configured the trap destinations, press the
[Save Data]
function key.
3. Press the
[Go to Filter]
key to configure authorization filters or the
[GoToMIB]
key to
configure MIB parameters. Or, if you have completed configuration for your DTCs,
press
[Validate DTS/LINK]
to validate your configuration.