Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90057)

Additional DTC Configuration
Configuring SNMP
Chapter 8
152
The SNMP MIB Configuration screen for host-based management is shown below, in
Figure 8-5.
Figure 8-5 SNMP MIB Configuration Screen
The “DTC Name” field is a read-only field which indicates the SNMP configuration is for
that specific DTC.
1. The “SysContact”, “SysName”, and “SysLocation” fields provide optional
information about the DTC such as contact person, the DTC’s fully-qualified name
and physical location.
Each field allows text up to 256 alphanumeric characters and is case sensitive.
2. The “Enable authentication traps” field indicates whether the SNMP agent
should generate authentication failure traps. Enter Y to enable trap generation (see
the section on “Configuring Trap Destinations”); enter N to disable it.
3. After you have configured the MIB parameters, press the
[Save Data]
function key.
4. Press the
[Go To Trap]
key to configure trap destinations or the
[Go To Filter]
key to
configure authorization filters. Or, if you have completed configuration for your
DTCs, press
[Validate DTS/LINK]
to validate your configuration.