Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

98 Chapter6
Configuring Serial Devices (for PC-Based Management)
Modify the Network Management Configuration File
NOTE If you want the HP 3000 system to be able to accept connections from
terminals on ARPA systems via a Telnet Express Server, you must use
a modem profile for the non-nailed terminals, such as TR10U24. Note
that you may use direct connect devices on a port with a modem profile.
See the Host-Based Terminal Profiles table in Chapter 7, “Terminal and
Printer Profiles,” for a list of available profiles. You may also create your
own profile. For more information on profiles, refer to Chapter 7,
“Terminal and Printer Profiles.”
7. Enter the desired number of non-nailed PAD terminals to be allowed
on the HP 3000. Currently, NMMGR allows the configuration of up
to 4649 terminal I/O devices.
8. Enter the ldev number where the non-nailed pool should start. The
non-nailed devices will be configured on ldevs with the starting ldev
number and higher.
For example if the number of ldevs is 2 and the starting number is
200 then the non-nailed ldev would be 200 and 201. If 201 is already
configured as a nailed device then the non-nailed device would be
200 and 202.
9. Enter the profile to use for the non-nailed PAD terminals.
10.Press the
[Save Data] key.
This concludes NMMGR configuration for PC-based management for
this HP 3000 computer if this computer will not be accessing any nailed
devices.
If the HP 3000 computer needs to access nailed ports in one or more
DTCs, press the
[Go To DTC] key and proceed to Step 5 to configure the
nailed ports. Note that printers and UPSs are nailed devices, so you
need to configure any DTC that has printer or UPS ports.
NOTE You can type “help whatsnew” at the command line of this screen for
more information on DTS dynamic configuration. You can also refer to
Chapter 4, “Dynamic Configuration and DTS Shutdown/Restart,” for
more information on how to make DTS configuration changes
dynamically. Automatic DTC configuration is available for host-based
environments only.