Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

Chapter 6 97

Conﬁguring Serial Devices (for PC-Based Management)

Modify the Network Management Conﬁguration File

Step 4: Conﬁgure the Link

The Host Conﬁguration screen is displayed when you press the [DTS]

key at the Main screen (Figure 6-3).

Figure 6-3 Host Conﬁguration Screen (PC-Based)

1. “Local HP 3000 node name” is a display-only ﬁeld. Verify that it

is correct.

2. Use the default link name, DTSLINK.

3. Enter the slot number of the LANIC in the “Physical path of

LANIC” ﬁeld. See Chapter 2, “Before Conﬁguring Terminal and

Printer Connections,” for a list of suggested slot numbers to use.

4. Enter the desired number of non-nailed terminals to be allowed on

the HP 3000. Currently, NMMGR allows the conﬁguration of up to

4649 terminal I/O devices.

5. Enter the ldev number where the non-nailed pool should start. The

non-nailed devices will be conﬁgured on ldevs with the starting ldev

number and higher.

For example if the number of ldevs is 2 and the starting number is

200 then the non-nailed ldev would be 200 and 201. If 201 is already

conﬁgured as a nailed device then the non-nailed device would be

200 and 202.

6. Enter the proﬁle to use for the non-nailed terminals.