Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

Chapter 6 93
Configuring Serial Devices (for PC-Based Management)
Copy the Sample File
Copy the Sample File
Network information is stored in a configuration file called
NMCONFIG.PUB.SYS. If you do not already have a NMCONFIG.PUB.SYS
file, create a copy of NMCONFIG.PUB.SYS from the sample configuration
file supplied on the HP 3000, NMSAMP1.PUB.SYS.
To copy NMSAMP1.PUB.SYS into NMCONFIG.PUB.SYS, enter these
commands at the MPE/iX prompt (:):
HELLO MANAGER.SYS,PUB
FILE CONFIG=NMCONFIG.PUB.SYS;DEV=1
FCOPY FROM=NMSAMP1.PUB.SYS;TO=*CONFIG;NEW
NOTE “DEV=1” must be specified in the FILE equation to specify that the
NMCONFIG.PUB.SYS file is to be stored to system disk 1.
CAUTION If ANY other configuration file is copied to NMCONFIG.PUB.SYS
NMCONFIX.PUB.SYS then dynamic configuration will be disabled until
a DTS shutdown and restart is done or the system is rebooted. This
includes other files from the same system or files copied from other
systems.